Zeni SLS Free MAXI Aloe Vera Clear is a clear glycerine-based soap base formulated with natural Aloe Barbadensis Leaf Juice. Aloe vera helps to create a gentle and skin-friendly handcrafted soap, providing a pleasant experience for everyday care.
The soap has a very good transparency and a rich lather.
The soap paste sets relatively slowly, allowing the production of detailed design soaps and multi-layer compositions. The very strong adhesion of the layers (by spraying over with alcohol) helps to achieve a professional result. The soap paste does not contain any animal ingredients and has not been tested on animals.
The SLS-free formulation means that the formula does not contain the strong detergent Sodium Lauryl Sulfate, so the soap is gentler on the skin while maintaining a good cleansing effect.
Main features
- Contains natural aloe vera juice
- Very good transparency
- Lowsweat property – less moisture on the surface of the soap
- Rich foaming
- Gentle sensation on the skin
- Very strong layer adhesion
- SLS-free (for delicate skin)
- No animal ingredients
- Not tested on animals
Ingredients
Aqua, glycerine, sodium stearate, propylene glycol, sodium laurate, sodium laureth sulphate, sorbitol, aloe barbadensis leaf juice, sodium chloride, disodium laureth sulphosuccinate, tetrasodium EDTA.
How to make soap?
It’s easy to make soap from ready-made soap mix:
- Cut the mass into cubes (1-3 cm).
- Melt the cubes in a hot water bath at 65-70°C or in a microwave (approx. 400-500 W).
- Do not let the temperature exceed 75°C.
- Avoid boiling.
3. Add aromas and colours.
- Recommended amount of fragrance oils or essential oils: 10-20 g/kg.
- You can find the maximum amount of fragrance oil allowed under the relevant IFRA category of fragrance oil – always follow the limits set by IFRA.
- Add the colourant drop by drop until the desired result is achieved.
- Shea butter, cocoa butter, almond oil, coconut oil or olive oil can also be added to skin care products if desired. Usually not more than ~15 g/kg is recommended to prevent the soap from becoming too soft. Mix all the additives into the soap mixture and make sure that all the additives are well mixed into the soap mixture.
4. Pour into the mould and leave to set (about 20-40 min).
On average, 1 kg of soap paste can be used to make about 10 medium-sized soaps. We recommend packaging the finished soap in a film after removing it from the mould to avoid evaporation of moisture.
